P2118

P2118 THROTTLE CONTROL MOTOR

Component Description

The throttle control motor is operated by the ECM and it opens and closes the throttle valve.
The current opening angle of the throttle valve is detected by the throttle position sensor The throttle sensor provides feedback to the ECM, when opens/closes the throttle valve in response to driving conditions via the throttle control motor.


On Board Diagnosis Logic

This self-diagnosis has the one trip detection logic.






FAIL-SAFE MODE

When the malfunction is detected, the ECM enters fail-safe mode and the MIL illuminates.







DTC Confirmation Procedure

1.If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
a.Turn ignition switch OFF and wait at least 10 seconds.
b.Turn ignition switch ON.
c.Turn ignition switch OFF and wait at least 10 seconds.
2.Turn ignition switch ON and wait at least 2 seconds.
3.Start engine and let it idle for 5 seconds.
4.Check DTC.
5.If DTC is detected, go to Diagnosis Procedure (see below).


Diagnosis Procedure


1. CHECK GROUND CONNECTIONS

1.Turn ignition switch OFF.
2.Loosen and retighten three ground screws on the body. Power Supply And Ground Circuit.





OK or NG
OK- GO TO 2.
NG- Repair or replace ground connections.

2. CHECK THROTTLE CONTROL MOTOR OUTPUT SIGNAL CIRCUIT FOR OPEN OR SHORT






1.Disconnect electric throttle control actuator harness connector.
2.Disconnect ECM harness connector.
3.Check harness continuity between the following terminals.
Refer to Wiring Diagram.





4.Also check harness for short to ground and short to power.
OK or NG
OK- GO TO 3.
NG- Repair or replace.

3. CHECK THROTTLE CONTROL MOTOR

.
OK or NG
OK- GO TO 4.
NG- GO TO 5.

4. CHECK INTERMITTENT INCIDENT

Intermittent Incident.
OK or NG
OK- GO TO 5.
NG- Repair or replace harness or connectors.

5. REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR

1.Replace the electric throttle control actuator. Exploded View.
2.Perform Throttle Valve Closed Position Learning.
3.Perform Idle Air Volume Learning.
-INSPECTION END


Component Inspection


THROTTLE CONTROL MOTOR

1.Disconnect electric throttle control actuator harness connector.





2.Check resistance between terminals 5 and 6.
Resistance: Approximately 1 - 15 ohms [at 25 �C (77�F)]
3.If NG, replace electric throttle control actuator and go to next step.
4.Perform Throttle Valve Closed Position Learning.
5.Perform Idle Air Volume Learning.