P1105

SYSTEM DESCRIPTION
This system allows the absolute pressure sensor to monitor either ambient barometric pressure or intake manifold pressure. The MAP/BARO switch solenoid valve switches between two passages by ON-OFF pulse signals from the ECM. (One passage is from the intake air duct, the other is from the intake manifold.) Either ambient barometric pressure or intake manifold pressure is applied to the absolute pressure sensor.




COMPONENT DESCRIPTION
The MAP/BARO switch solenoid valve switches its air flow passage according to the voltage signal sent from the ECM. When voltage is supplied from the ECM, the MAP/BARO switch solenoid turns "ON". Then, the absolute pressure sensor can monitor the ambient barometric pressure. When voltage is not supplied from the ECM, the MAP/BARO switch solenoid valve turns "OFF". Then, the sensor monitors intake manifold pressure.




DIAGNOSTIC TROUBLE CODE CONFIRMATION PROCEDURE
WITH CONSULT
(1) Start engine and warm it up sufficiently.
(2) Turn ignition switch "OFF" and wait at least 5 seconds.
(3) Turn ignition switch "ON" and select "DATA MONITOR" mode with CONSULT.
(4) Start engine and let it idle.
(5) Wait at least 8 seconds.

OR

WITH GST
(1) Start engine and warm it up sufficiently.
(2) Turn ignition switch "OFF" and wait at least 5 seconds.
(3) Start engine and let it idle.
(4) Wait at least 8 seconds.
(5) Select "MODE 3" with GST.

OR

WITH NO TOOLS
(1) Start engine and warm it up sufficiently.
(2) Turn ignition switch "OFF" and wait at least 5 seconds.
(3) Start engine and let it idle.
(4) Wait at least 8 seconds.
(5) Turn ignition switch "OFF", wait at least 5 seconds and then turn "ON".
(6) Perform "Diagnostic Test Mode II (Self-diagnostic results)" with ECM.

EC-SW/V-01 Manifold Absolute Pressure (MAP)/Barometric Pressure (BARO) Switch Solenoid Valve (DTC: 1302):

WIRING DIAGRAM







DIAGNOSTIC PROCEDURE

COMPONENT INSPECTION
WITH CONSULT
1. Start engine and warm it up sufficiently.
2. Perform "MAP/BARO SW/V" in "ACTIVE TEST" mode with CONSULT.
3. Check the following.




- When "MAP" is selected, "ABSOL PRES/SE" indicates approximately 1.3V.




- When "BARO" is selected, "ABSOL PRES/SE" indicates approximately 4.3V.
4. If NG, replace solenoid valve.

OR

WITH NO TOOLS
1. Remove MAP/BARO switch solenoid valve.




2. Check air passage continuity.




3. If NG, replace solenoid valve.