With Manufacturer's Scan Tool

CONSULT-II Function (TCM)

After performing "SELF-DIAGNOSTIC PROCEDURE (WITH CONSULT-II)", place check marks for results on the "DIAGNOSTIC WORKSHEET" Work Flow





NOTICE:
1. The CONSULT-II electrically displays shift timing and lock-up timing (that is, operation timing of each solenoid).
Check for time difference between actual shift timing and the CONSULT-II display. If the difference is noticeable, mechanical parts (except solenoids, sensors, etc.) may be malfunctioning. Check mechanical parts using applicable diagnostic procedures.
2. Shift schedule (which implies gear position) displayed on CONSULT-II and that indicated in Service Manual may differ slightly. This occurs because of the following reasons:
^ Actual shift schedule has more or less tolerance or allowance,
^ Shift schedule indicated refers to the point where shifts start, and
^ Gear position displayed on CONSULT-II indicates the point where shifts are completed.
3. Display of solenoid valves on CONSULT-II changes at the start of shifting, while gear position is displayed upon completion of shifting (which is computed by TCM).
4. Additional CONSULT-II information can be found in the Operation Manual supplied with the CONSULT-II unit.

CONSULT-II SETTING PROCEDURE

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

^ For details, refer to the separate "CONSULT-II Operations Manual".





1. Turn ignition switch "OFF".
2. Connect CONSULT-II and CONSULT-II CONVERTER to data link connector, which is located in driver instrument panel (lower).
3. Turn ignition switch "ON". (Do not start engine.)





4. Touch "START (NISSAN BASED VHCL)".





5. Touch"A/T".
If "A/T" is not indicated, go to GI-36. "CONSULT-II Data Link Connector (DLC) Circuit". CONSULT-II Checking System
6. Perform each diagnostic test mode according to each service procedure.

WORK SUPPORT MODE





Work item

SELF-DIAG RESULT MODE

Operation procedure
1. Perform "CONSULT-II SETTING PROCEDURE". Refer to AT-75, "CONSULT-II SETTING PROCEDURE"





2. Touch"SELF-DIAG RESULTS". Display shows malfunction experienced since the last erasing operation.

NOTE:
^ The details for "TIME" are as follow:
^ "CRNT": Error currently detected with TCM.
^ "PAST": Error detected in the past and memorized with TCM.
^ Touch "F.F.DATA" on "SELF-DIAG RESULTS" screen to display freeze frame data. Freeze frame data shows driving condition when malfunction is detected.
For freeze frame data items, refer to "Display item list"








Display item list

DATA MONITOR MODE

Operation procedure
1. Perform "CONSULT-II SETTING PROCEDURE". Refer to AT-75. "CONSULT-II SETTING PROCEDURE"
2. Touch "DATA MONITOR".

NOTE: When malfunction is detected, CONSULT-II performs REAL-TIME DIAGNOSIS. Also, any malfunction detected while in this mode will be displayed at real time.











Display item list

ACTIVE TEST MODE





Test item

NOTE: Approximately 10 seconds after the operation is begun, "TEST IS STOPPED" will be displayed.