Removal And Installation

HEADLINING


Removal and Installation


REMOVAL
1. Remove front pillar garnish (LH/RH) and body side welt (LH/RH). Refer to Removal And Installation.





2. Remove roof harness assembly fixing clips (B) with remover tool, and then disconnect roof harness connector (A).

3. Disconnect inside mirror harness connector.
4. Remove sunvisor assembly (LH/RH).
- Remove sunvisor cover.
- Remove sunvisor assembly fixing screws.
- Disconnect vanity mirror lamp harness connectors.





5. Insert small flat-bladed screwdriver into the hole of sunvisor holder, press while rotating approximately 90 degrees to remove.
6. Remove kicking plate inner (LH/RH) and rear pillar finisher (LH/RH). Refer to Removal And Installation.





7. Insert remover tool between roof panel and roof console assembly (front edge) to disengage the metal clips as shown in the figure.

8. With remover tool, remove headlining clip from rear end of headlining.
9. Put front seat to rearmost and recline backward.





10. Remove headlining, turn and take out from right side door.

CAUTION:
- When removing headlining, 2 workers are required. (1 for the front and rear of headlining)
- Cover center console finisher upper surface with a shop cloth to prevent it from being damaged.
- Never bend headlining when removing.
11. Remove the following parts after removing headlining.
- Map lamp assembly. Refer to Exploded View.
- Roof harness assembly.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
- Install headlining assembly after inserting clips to clip holder of headlining rear end.
- Never bend headlining when installing.