Removal And Installation

BODY SIDE TRIM


Removal and Installation


CAUTION:
- Wrap the tip of flat-bladed screwdriver with a shop cloth before removing metal clips from garnishes.
- When removing, always use a remover tool that is made of plastic.
- Never damage the body.

REMOVAL

FRONT PILLAR GARNISH
1. Release front pillar portion of body side welt.
2. Disengage front pillar garnish fixing clip and metal clip with remover tool (A), cut clip (2) with cutter knife, and then remove front pillar garnish (1).






KICKING PLATE INNER
1. Pull up kicking plate inner to disengage the pawls.





2. Remove kicking plate inner from body panel.

DASH SIDE FINISHER
1. Remove kicking plate inner.





2. Remove clip (A).
3. Remove dash side finisher (1) fixing clips with remover tool (B), and then remove dash side finisher.

KICKING PLATE OUTER
Remove kicking plate outer fixing clips with a remover tool, and then remove kicking plate outer.






BODY SIDE WELT
1. Remove kicking plate inner.
2. Remove body side welt.

REAR SIDE FINISHER
1. Remove kicking plate inner.
2. Slide the seat assembly toward the front most position (Driver and passenger side).
3. Remove body side welt from the rear side finisher.
4. Remove tonneau cover (With tonneau cover). Refer to Exploded View.





5. Remove the rear side finisher mounting bolts (A) (LH/RH) after removing the tonneau cover.
6. Remove the rear parcel shelf side finisher (LH/RH). Refer to Removal And Installation.
7. Remove the rear parcel shelf cover (LH/RH). Refer to Removal And Installation.

NOTE:
Remove rear parcel shelf finisher holder before removing rear parcel shelf cover (Passenger side).
8. Remove rear parcel shelf finisher holder. Refer to Removal And Installation.
9. Remove the luggage side finisher upper (LH/RH). Refer to Removal And Installation.
10. Insert remover tool into the clearance between rear side finisher and body panel, disengage the clips, pawls and disconnect the rear speaker harness connector (with BOSE audio).
11. Remove rear side finisher.

REAR PILLAR FINISHER
1. Remove rear side finisher.
2. Remove seat belt shoulder anchor mounting bolt. Refer to Exploded View.
3. Remove seat belt floor anchor bolt. Refer to Exploded View.





4. Insert remover tool between body panel and rear pillar finisher to disengage the pawls and clips.

5. Disconnect the outside key antenna harness connectors.
6. Remove rear pillar finisher from the body panel.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.