Removal And Installation

REAR TRIM


Removal and Installation


REMOVAL

REAR PARCEL SHELF SIDE FINISHER
1. Remove tonneau cover (With tonneau cover).





2. Slide rear parcel shelf side finisher toward the direction of the arrow to remove.

REAR PARCEL SHELF COVER
Remove rear parcel shelf cover LH with remover tool as shown in the figure.





REAR PARCEL SHELF FINISHER HOLDER
1. Fully open rear parcel shelf finisher holder in three steps as shown in the figure below.(Approximately 45 degree)
2. Pull back to remove.






SEATBACK CENTER FINISHER
1. Remover center console assembly. Refer to Removal And Installation.
2. Remove rear side finisher. Refer to Removal And Installation.
3. Disconnect seatback center finisher fixing clips, and then pull it up to remove.

REAR PARCEL SHELF FINISHER
1. Remove seatback center finisher.






Arrow indicates Vehicle Front

2. Remove the clips (A) with a remover tool.
3. Hold rear parcel shelf finisher (1) from both sides, and then pull it back to remove.

REAR PARCEL SHELF BRACKET
1. Remove rear parcel shelf finisher.





2. Remove rear parcel shelf bracket (1) mounting bolts (A) (LH/RH).

BACK PANEL FINISHER ASSEMBLY
1. Remove luggage floor spacer front. Refer to Exploded View.
2. Remove rear side finisher. Refer Removal And Installation.
3. Remove rear pillar finisher. Refer to Removal And Installation.





4. Remove the clips (A) fixing the back panel finisher assembly (1) to the rear parcel shelf bracket.

5. Pull back panel finisher assembly to remove.

INSTALLATION
Install in the reverse order of removal.

CAUTION:
Check that clips are securely fitted in panel holes on body when installing, and then press them in.