B2604
B2604 TRANSMISSION RANGE SWITCH
Description
BCM confirms the shift position with the following 3 signals.
- CVT selector lever
- Transmission range switch
- P position signal from hybrid vehicle control ECU
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. SEC.
- If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. SEC.
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the hybrid system under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P position
- Do not depress the brake pedal
- Use CVT selector lever to select each gear, one at a time. Wait at each gear position for at least 1 second.
2. Check "Self diagnostic result" with CONSULT-III.
Is DTC detected?
YES - B2604.
NO - Inspection End.
Diagnosis Procedure
Regarding Wiring Diagram information, Intelligent Key System/Engine Start Function.
1.CHECK DTC WITH HV ECU
Check "Self diagnostic result" with CONSULT-III. Testing and Inspection.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace malfunctioning parts.
2.CHECK TRANSMISSION RANGE SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect hybrid vehicle control ECU harness connector and BCM harness connector.
3. Check continuity between hybrid vehicle control ECU harness connector and BCM harness connector.
4. Check continuity between hybrid vehicle control ECU harness connector and ground.
Is the inspection result normal?
YES - GO TO 3
NO - Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- Inspection End.