Sedan Without Intelligent Key

B2555 STOP LAMP

Description
BCM detects the stop lamp status and confirms the stop lamp switch ON/OFF status. BCM confirms the engine start condition according to the stop lamp switch ON/OFF status.

DTC Logic

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Depress the brake pedal and wait for at least 1 second.
2. Check "Self Diagnostic Result" with CONSULT-III.
Is DTC detected?
YES - Refer to Sedan Without Intelligent Key.
NO - Inspection End.

Diagnosis Procedure
Regarding Wiring Diagram information, refer to NVIS - With Remote Keyless Entry.
1.CHECK STOP LAMP SWITCH INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect BCM harness connector.

3. Check voltage between BCM harness connector and ground.

Is the inspection result normal?
YES - Stop lamp switch is OK.
NO - GO TO 2
2.CHECK STOP LAMP SWITCH POWER SUPPLY CIRCUIT
1. Disconnect stop lamp switch harness connector.

2. Check voltage between stop lamp harness connector and ground.

Is the inspection result normal?
YES - GO TO 3
NO - Check harness for open or short between stop lamp switch and fuse.
3.CHECK STOP LAMP SWITCH CIRCUIT

1. Check continuity between stop lamp switch harness connector
E38 (A) terminal 2 and BCM harness connector M18 (B) terminal 26.

2. Check continuity between stop lamp switch harness connector
E38 (A) terminal 2 and ground.

Is the inspection result normal?
YES - GO TO 4
NO - Repair harness or connector.
4.CHECK STOP LAMP SWITCH
Refer to Sedan Without Intelligent Key.
Is the inspection result normal?
YES - GO TO 5
NO - Replace stop lamp switch.
5.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- Inspection End.

Component Inspection
1.CHECK STOP LAMP SWITCH
1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector.

3. Check continuity between stop lamp switch terminals under the following conditions.

Is the inspection result normal?
YES - Inspection End.
NO - Replace stop lamp switch.