Operation CHARM: Car repair manuals for everyone.

CVT RE0F10A


P1705 TP SENSOR





Description
Electric throttle control actuator consists of throttle control motor, accelerator pedal position sensor, throttle position sensor etc. The actuator sends a signal to the ECM, and ECM sends the signal to TCM with CAN communication.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Depress accelerator pedal fully and release it, then wait for 5 seconds.
3. Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
Is "P1705" detected?
YES - Go to CVT RE0F10A.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK DTC WITH ECM
With CONSULT-III
1. Turn ignition switch ON.
2. Perform "SELF-DIAG RESULTS" mode for "ENGINE".
Is the inspection result normal?
YES - GO TO 2.
NO - Check DTC Detected Item. Refer to Testing and Inspection (for California), Testing and Inspection(except for California).
2.CHECK DTC WITH TCM
With CONSULT-III
Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
Is "P1705" detected?
YES - Replace TCM. Refer to Exploded View.
NO - GO TO 3.
3.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.