Sedan Without Intelligent Key

B2604 TRANSMISSION RANGE SWITCH





Description
BCM confirms the shift position with the following 4 signals.
- CVT selector lever
- Transmission range switch
- P position signal from IPDM E/R (CAN)
- P position signal from TCM (CAN)




DTC Logic

DTC DETECTION LOGIC

NOTE:
- If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to Sedan Without Intelligent Key.
- If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to Sedan Without Intelligent Key.






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Start the engine under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P position
- Do not depress the brake pedal
2. Use CVT selector lever to select each gear one at a time. Wait at each gear for at least 1 second.
3. Check "Self diagnostic result" with CONSULT-III.
Is DTC detected?
YES - Refer to Sedan Without Intelligent Key.
NO - Inspection End.




Diagnosis Procedure
Regarding Wiring Diagram information, refer to NVIS - With Remote Keyless Entry.
1.CHECK DTC WITH TCM
Check "Self diagnostic result" with CONSULT-III. Refer to Testing and Inspection.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace malfunctioning parts.
2.CHECK TRANSMISSION RANGE SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect TCM harness connector and BCM harness connector.





3. Check continuity between TCM harness connector and BCM harness connector.





4. Check continuity between TCM harness connector and ground.






Is the inspection result normal?
YES - GO TO 3
NO - Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- Inspection End.