Sedan Without Intelligent Key

B2605 TRANSMISSION RANGE SWITCH





Description
BCM confirms the shift position with the following 4 signals.
- CVT selector lever
- P/N position switch
- P position signal from IPDM E/R (CAN)
- P position signal from TCM (CAN)




DTC Logic

DTC DETECTION LOGIC

NOTE:
- If DTC B2605 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to Sedan Without Intelligent Key.
- If DTC B2605 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to Sedan Without Intelligent Key.






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON under the following conditions and wait for at least 1 second.
- CVT selector lever is in the P or N position
- Do not depress the brake pedal.
2. Check "Self diagnostic result" with CONSULT-III.
Is DTC detected?
YES - Refer to Sedan Without Intelligent Key.
NO - Inspection End.




Diagnosis Procedure
Regarding Wiring Diagram information, refer to NVIS - With Remote Keyless Entry.
1.CHECK DTC WITH IPDM E/R
Check "Self diagnostic result" with CONSULT-III. Refer to Testing and Inspection.
Is the inspection result normal?
YES - GO TO 2
NO - Repair or replace malfunctioning parts.
2.CHECK TRANSMISSION RANGE SWITCH CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect TCM harness connector and BCM harness connector.





3. Check continuity between TCM connector and BCM harness connector.





4. Check continuity between TCM harness connector and ground.






Is the inspection result normal?
YES - GO TO 3
NO - Repair harness or connector.
3.CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
- Inspection End.