CVT RE0F09B

P0705 TRANSMISSION RANGE SWITCH A





Description
- The transmission range switch is included in the control valve assembly.
- The transmission range switch includes 4 transmission position switches.
- TCM judges the selector lever position by the transmission range switch signal.









DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "DATA MONITOR".
3. Start engine.
4. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.





With GST
Follow the procedure "With CONSULT-III".
Is "P0705" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK CVT POSITION
1. Disconnect CVT unit harness connector.
2. Remove control cable from manual lever. Refer to Exploded View.
3. Check transmission range switch. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - Adjust CVT position. Refer to CVT RE0F09B.
NO - GO TO 2.
2. CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 1)





1. Turn ignition switch OFF.
2. Disconnect TCM harness connector.
3. Check continuity between TCM harness connector F16 (A) terminal 1, 2, 3, 4, 11 and CVT unit harness connector F46 (B) terminal 5, 14, 15, 18, 4.






Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3. CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 2)





Check continuity between TCM harness connector F16 terminal 1, 2, 3, 4, 11 and ground.






Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace the TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.




Component Inspection (Transmission Range Switch)
1.CHECK TRANSMISSION RANGE SWITCH





Check the continuity of the transmission range switch by changing selector lever to various positions and checking continuity between
CVT unit terminals and ground.






Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Refer to Exploded View.