CVT RE0F09B

P1777 STEP MOTOR





Description
The step motor changes the step with turning 4 coils ON/OFF according to the signal from TCM. As a result, the flow of line pressure to primary pulley is changed and pulley ratio is controlled.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Start engine.
2. Drive vehicle for at least 5 consecutive seconds.
3. Perform "SELF-DIAG RESULTS" mode for "TRANSMISSION".
With GST
Follow the procedure "With CONSULT-III".
Is "P1777" detected?
YES - Go to CVT RE0F09B.
NO - Check intermittent incident. Refer to Intermittent Incident.




Diagnosis Procedure
1.CHECK STEP MOTOR CIRCUIT





1. Turn ignition switch OFF.
2. Disconnect TCM harness connector.
3. Check resistance between TCM harness connector F16 terminal
27, 29 and 28, 30.










4. Check resistance between TCM harness connector F16 terminal
27, 28, 29, 30 and ground.





Is the inspection result normal?
YES - GO TO 5.
NO - GO TO 2.
2.CHECK HARNESS BETWEEN TCM AND CVT UNIT (STEP MOTOR) (PART 1)





1. Disconnect CVT unit harness connector.
2. Check continuity between TCM harness connector F16 (A) terminal 27, 28, 29, 30 and CVT unit harness connector F46 (B) terminal 9, 8, 7, 6.






Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3.CHECK HARNESS BETWEEN TCM AND CVT UNIT (STEP MOTOR) (PART 2)





Check continuity between TCM harness connector F16 terminal 27, 28, 29, 30 and ground.





Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.CHECK STEP MOTOR
Check step motor. Refer to CVT RE0F09B.
Is the inspection result normal?
YES - GO TO 5.
NO - Replace transaxle assembly. Refer to Exploded View.
5.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Refer to Exploded View.
NO - Repair or replace damaged parts.




Component Inspection (Step Motor)
1.CHECK STEP MOTOR





1. Check resistance between CVT unit terminal 6, 8 and 7, 9.










2. Check resistance between CVT unit terminal 6, 7, 8, 9 and ground.





Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Refer to Exploded View.