Operation CHARM: Car repair manuals for everyone.

B210F


B210F SHIFT POSITION/CLUTCH INTERLOCK SWITCH





Description
IPDM E/R confirms the shift position with the following signals.
- Transmission range switch
- Shift position signal from BCM (CAN)




DTC Logic

DTC DETECTION LOGIC

NOTE:
- If DTC B210F is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. With Intelligent Key System.
- If DTC B210F is displayed with DTC B2603, first perform the trouble diagnosis for DTC B2603. B2603.






DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Turn ignition switch ON under the following conditions and wait 1 second or more.
- Selector lever is in the P or N position
- Do not depress brake pedal
2. Check "Self-diagnosis result" using CONSULT-III.
Is DTC detected?
YES - Go to B210F.
NO - INSPECTION END




Diagnosis Procedure
1.CHECK IPDM E/R INPUT SIGNAL
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Turn ignition switch ON.
4. Check voltage between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES - Replace IPDM E/R. With I-Key.
NO - GO TO 2.
2.CHECK IPDM E/R SIGNAL CIRCUIT SHORT
1. Disconnect transmission range switch connector.
2. Check continuity between IPDM E/R harness connector and ground.





Is the inspection result normal?
YES - Replace IPDM E/R. With I-Key.
NO - Repair or replace harness.