Removal And Installation

CONTROL LINKAGE


Removal and Installation


REMOVAL
1. Pull the shifter lever knob upward to remove.
2. Remove center console assembly. Removal And Installation.
3. Remove harness clips.
4. Shift the shifter lever in the neutral position.
5. Remove mounting bolts of the control device.
6. Remove air duct (inlet). Removal And Installation.
7. Remove battery. Removal And Installation.
8. Remove clips from the air duct and air cleaner case. Removal And Installation.
9. Remove air cleaner case and air ducts. Removal And Installation.
10. Pull out and disconnect the each cable from the shifter lever A and the selector lever, using a suitable remover.
11. Remove each lock plate upward to disconnect the each cable from the cable mounting bracket.
12. Remove cable mounting bracket from the transaxle case.
13. Remove center muffler, exhaust front tube, and heat plate. Removal And Installation.
14. Remove bracket from the vehicle.
15. Release the tabs (A) on the front and back of the control device
(1) to remove the control device from under the vehicle.






Arrow Indicates : Vehicle front


INSTALLATION

Note the following, and install in the reverse order of removal.
- To install the shifter lever knob, press it into the shifter lever.

CAUTION:
- Never reuse shifter lever knob.
- Be careful with orientation of shifter lever knob.
- Shift the shifter lever in the neutral position.
- Tapping work for tapping bolts is not applied to new transaxle case. Do not perform tapping by other than screwing tapping bolts because tapping is formed by screwing tapping bolts into transaxle case.

CAUTION:
Never reuse tapping bolt.
- Shift the shifter lever A in the neutral position.
- Insert the each cable until it reaches the shifter lever A and the selector lever.
- The lock plate (1) which fixes the selector cable (2) has an indentation (Black Arrow). Never confuse the lock plate with the lock plate (3) which fixes the shifter cable (4).






Arrow Indicates : Vehicle front

- Insert the each lock plate until it reaches the cable mounting bracket.

Install the selector cable according to the following instructions.





1. Install the selector cable (1) on the cable mounting bracket to install the lock plate.
2. Install the selector cable on the selector lever (2).
3. Slide the stopper (3) in the direction of the arrow (A) shown in the figure.
4. Press the lock (4) in the direction of the arrow (B) shown in the figure.

CAUTION:
Never move the selector lever.
5. Side the stopper in the direction of the arrow (C) shown in the figure.

CAUTION:
Never move the selector lever.