C1708

C1708 - C1711 DATA FROM TRANSMITTER NOT BEING RECEIVED





Description
Tire pressure data for one or more transmitters is not being received by the BCM.




DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE
1.ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. ID Registration Procedure.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-III within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES - Inspection End.
NO - C1708.




Diagnosis Procedure
MALFUNCTION CODE NO. 21, 22, 23 OR 24 (DTC C1708, C1709, C1710 OR C1711)
1.CHECK BCM
Drive for several minutes. Check all tire pressures with CONSULT-III.
Are all tire pressures displayed as 0 kPa?
YES - GO TO 2
NO - GO TO 3
2.CHECK TIRE PRESSURE RECEIVER CONNECTOR
Check tire pressure receiver connector for damage or loose connections.
Is the inspection result normal?
YES - Replace BCM, then GO TO 3. Body Control System.
NO - Repair or replace tire pressure receiver connector.
3.PERFORM ID REGISTRATION
Carry out ID registration of all transmitters. ID Registration Procedure.
Is there a tire that cannot register ID?
YES - Replace malfunctioning transmitter, then GO TO 5. Service and Repair.
NO - GO TO 4
4.DRIVE VEHICLE
1. Drive at a speed of 40 km/h (25 MPH) or more for several minutes without stopping.
2. Check all tire pressures with CONSULT-III within 15 minutes after vehicle speed becomes 17 km/h (11 MPH).
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES - Inspection End.
NO - GO TO 5
5.ID REGISTRATION AND VEHICLE DRIVING
1. Carry out ID registration of all transmitters. ID Registration Procedure.
2. Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3. Check all tire pressures with CONSULT-III within 5 minutes.
Does "DATA MONITOR ITEM" display tire pressure as normal without any warning lamp?
YES - Inspection End.
NO - Proceed to the inspection applicable to DTC.




Special Repair Requirement
Perform preliminary check. Preliminary Check.