Operation CHARM: Car repair manuals for everyone.

P0705


P0705 TRANSMISSION RANGE SWITCH A





Description
- The Transmission range switch is included in the control valve assembly.
- The Transmission range switch includes 4 transmission position switches.
- TCM judges the selector lever position by the Transmission range switch signal.









DTC Logic

DTC DETECTION LOGIC






DTC CONFIRMATION PROCEDURE

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
Immediately after performing any "DTC CONFIRMATION PROCEDURE", always turn ignition switch OFF.
Then wait at least 10 seconds before performing the next test.
1.CHECK DTC DETECTION
With CONSULT-III
1. Turn ignition switch ON.
2. Select "Data Monitor" in "TRANSMISSION".
3. Start engine.
4. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.





With GST
Follow the procedure "With CONSULT-III".
Is "P0705" detected?
YES - Go to P0705.
NO - Check intermittent incident. Intermittent Incident.




Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1.CHECK CVT POSITION
1. Disconnect CVT unit connector.
2. Remove control cable from manual lever. Exploded View.
3. Check transmission range switch. P0705.
Is the inspection result normal?
YES - Adjust CVT position. Adjustments.
NO - GO TO 2.
2. CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 1)





1. Turn ignition switch OFF.
2. Disconnect TCM connector.
3. Check continuity between TCM vehicle side harness connector terminals and CVT unit vehicle side harness connector terminals.






Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace damaged parts.
3. CHECK HARNESS BETWEEN TCM AND TRANSMISSION RANGE SWITCH (PART 2)





Check continuity between TCM vehicle side harness connector terminals and ground.






Is the inspection result normal?
YES - GO TO 4.
NO - Repair or replace damaged parts.
4.DETECT MALFUNCTIONING ITEMS
Check TCM connector pin terminals for damage or loose connection with harness connector.
Is the inspection result normal?
YES - Replace TCM. Exploded View.
NO - Repair or replace damaged parts.




Component Inspection (Transmission Range Switch)
1.CHECK TRANSMISSION RANGE SWITCH





Check the continuity of the transmission range switch by changing selector lever to various positions and checking continuity between CVT unit terminals and ground.






Is the inspection result normal?
YES - INSPECTION END
NO - Replace transaxle assembly. Exploded View.