For California

DTC P0607 ECM





Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN H line, CAN L line) allowing a high rate of information transmission with less wiring.
Each control unit transmits/receives data but selectively reads required data only.




On Board Diagnosis Logic
This self-diagnosis has the one trip detection logic (CVT).
The MIL will not light up for this self-diagnosis (M/T).









DTC Confirmation Procedure
1. Turn ignition switch ON.
2. Check 1st trip DTC.
3. If 1st trip DTC is detected, go to For California.




Diagnosis Procedure
1.INSPECTION START
1. Erase DTC.
2. Perform DTC Confirmation Procedure.
See For California.
3. Is the 1st trip DTC P0607 displayed again?
Yes or No
Yes - GO TO 2.
No - INSPECTION END
2.REPLACE ECM
1. Replace ECM.
2. Perform initialization of NVIS (NATS) system and registration of all NVIS (NATS) ignition key IDs. Programming and Relearning.
3. Perform For California.
4. Perform For California.
5. Perform For California.
6. Perform For California.
- INSPECTION END