P0451
DTC P0451 EVAP CONTROL SYSTEM PRESSURE SENSOR
Component Description
The EVAP control system pressure sensor (1) detects pressure in the purge line. The sensor output voltage to the ECM increases as pressure increases.
- This illustration is a view from under vehicle
- EVAP canister (2)
- EVAP canister vent control valve (3)
CONSULT-III Reference Value in Data Monitor Mode
Specification data are reference values.
On Board Diagnosis Logic
DTC Confirmation Procedure
NOTE:
If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
1. Start engine and wait at least 40 seconds.
NOTE:
Do not depress accelerator pedal even slightly.
2. Check 1st trip DTC.
3. If 1st trip DTC is detected, go to P0451.
Diagnosis Procedure
1.CHECK GROUND CONNECTIONS
1. Turn ignition switch OFF.
2. Loosen and retighten ground screws on the body. Ground Inspection.
OK or NG
OK - GO TO 2.
NG - Repair or replace ground connections.
2.CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR CONNECTOR FOR WATER
1. Disconnect EVAP control system pressure sensor (1) harness connector.
- This illustration is a view from under vehicle
- EVAP canister (2)
- EVAP canister vent control valve (3)
2. Check that water is not inside connectors.
OK or NG
OK - GO TO 3.
NG - Repair or replace harness connector.
3.CHECK POWER SUPPLY CIRCUITS
Check harness for short to power and short to ground, between the following terminals.
OK or NG
OK - GO TO 4.
NG - Repair short to ground or short to power in harness or connectors.
4.CHECK REFRIGERANT PRESSURE SENSOR
How To Perform Trouble Diagnosis For Quick And Accurate Repair MTC.
OK or NG
OK - GO TO 5.
NG - Replace refrigerant pressure sensor.
5.CHECK CRANKSHAFT POSITION SENSOR (POS)
P0452.
OK or NG
OK - GO TO 6.
NG - Replace crankshaft position sensor (POS).
6.CHECK APP SENSOR
P2127.
OK or NG
OK - GO TO 8.
NG - GO TO 7.
7.REPLACE ACCELERATOR PEDAL ASSEMBLY
1. Replace accelerator pedal assembly.
2. Perform Testing and Inspection.
3. Perform Throttle Valve Closed Position Learning.
4. Perform Programming and Relearning.
- INSPECTION END
8.CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR
P0451.
OK or NG
OK - GO TO 9.
NG - Replace EVAP control system pressure sensor.
9.CHECK INTERMITTENT INCIDENT
Description Diagnosis Procedure.
For wiring diagram, P0452.
- INSPECTION END
Component Inspection
EVAP CONTROL SYSTEM PRESSURE SENSOR
1. Remove EVAP control system pressure sensor with its harness connector connected from EVAP canister.
Always replace O-ring with a new one.
2. Install a vacuum pump to EVAP control system pressure sensor.
3. Turn ignition switch ON and check output voltage between ECM terminal 42 (EVAP control system pressure sensor signal) and ground under the following conditions.
CAUTION:
- Always calibrate the vacuum pump gauge when using it.
- Never apply below -93.3 kPa (-0.952 kg/cm2, -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm2, 14.69 psi).
4. If NG, replace EVAP control system pressure sensor.