Removal And Installation

CONTROL LINKAGE

Removal and Installation


REMOVAL

1.Move the shift selector to the neutral position.
2.Remove the battery tray. Removal and Replacement.
3.Pull out and disconnect cables from shifter lever A and selector lever, using a suitable tool.





4.While pressing the lock of the selector cable in the direction of the arrows shown, remove the selector cable from the cable mounting bracket.
5.While pressing the lock of the shifter cable in the direction of the arrows shown, remove the shifter cable from the cable mounting bracket.
6.Remove cable mounting bracket from clutch housing.
7.Pull the shift selector handle upward to remove.
8.Remove center console assembly. Removal And Installation.
9.Pull out and disconnect each cable from the M/T shift selector assembly, using a suitable tool.





a.While pressing the lock of the selector cable in the direction of the arrows shown, remove the selector cable from the M/T shift selector assembly.
b.While pressing the lock of the shifter cable in the direction of the arrows shown, remove the shifter cable from the M/T shift selector assembly.
10.Remove the M/T shift selector assembly.
11.Remove center muffler, exhaust front tube, and heat plate. Removal And Installation.
12.Remove the bracket from the vehicle.
13.Remove the grommet and then remove the shifter cable and selector cable from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
- Install each cable without causing interference with other parts. Do not allow cable to bend less than
120 mm (4.72 in), or exceed 180 degree twist.
- Install boot of each cable without causing interference with other parts. Do not exceed 90 degree twist.
- Fit boot to center console assembly and the groove on shift selector handle.
- To install the shift selector handle, press it onto the shift selector.

CAUTION:
- Do not reuse shift selector handle.
- Be careful with orientation of shift selector handle.
- Bolt hole is not threaded on new clutch housing. Self-tapping bolt is used to attach lock plate to clutch housing.

CAUTION:
Do not reuse self-tapping bolt.
- Insert each cable until it reaches the cable mounting bracket and M/T shift selector assembly.
- Insert each cable until it reaches the shifter lever A and the selector lever.
- Move the shift selector to the neutral position.