B0092
Description
DTC B0092 REAR SATELLITE SENSOR LH
The rear side air bag satellite sensor LH is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor the rear side air bag satellite sensor LH for internal failures and its circuits for communication errors.
PART LOCATION
Refer to "Component Parts Location" Locations.
DTC Logic
DTC DETECTION LOGIC
With CONSULT
Without CONSULT
DTC CONFIRMATION PROCEDURE (With CONSULT)
1. INSPECTION START
Turn ignition switch ON.
- GO TO 2.
2. CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT.
Is the DTC detected?
YES- Refer to "Diagnosis Procedure" .
NO- Inspection End.
DTC CONFIRMATION PROCEDURE (Without CONSULT)
NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1. IGNITION SWITCH
Turn ignition switch ON.
- GO TO 2
2. IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
- GO TO 3
3. WAIT TIME
Wait more than 3 seconds.
- GO TO 4
4. REPEAT STEPS
Repeat steps 1 to 3 twice.
- GO TO 5
5. IGNITION SWITCH
Turn ignition switch ON.
- GO TO 6
6. DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to "Flash Code Index" Manufacturer Code Charts.
- Inspection End.
Diagnosis Procedure
NOTE:
Follow the procedures in numerical order when repairing malfunctioning parts. Confirm whether malfunction is eliminated using air bag warning lamp each time repair is finished. If malfunction is still observed, proceed to the next step. When malfunction is eliminated, further repair work is not required.
1. HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES- Replace the harness.
NO- GO TO 2
2. WIRING HARNESS
Is there any visible damage to the harness?
YES or NO
YES- Replace the harness.
NO- GO TO 3
3. REAR SIDE AIR BAG SATELLITE SENSOR LH
Replace the rear side air bag satellite sensor LH. Refer to "Removal and Installation" Removal And Installation.
- GO TO 4
4. AIR BAG DIAGNOSIS SENSOR UNIT
Replace the air bag diagnosis sensor unit. Refer to "Removal and Installation" Service and Repair.
- GO TO 5
5. RELATED HARNESS
Replace the related harness.
- Inspection End.