Removal And Installation

HEADLINING

Removal and Installation


REMOVAL

1.Remove the front pillar finishers (LH/RH). Refer to "FRONT PILLAR FINISHER : Removal and Installation" Front Pillar Finisher.
2.Remove the center pillar upper finishers (LH/RH). Refer to "CENTER PILLAR UPPER FINISHER : Removal and Installation" Center Pillar Upper Finisher.
3.Remove the rear pillar finishers (LH/RH). Refer to "REAR PILLAR FINISHER : Removal and Installation" Rear Pillar Finisher.
4.Remove the rear seat bolsters (LH/RH). Refer to "Removal and Installation Rear Seat Bolster" Rear Seat Bolster.





5.Remove the sun visor caps (1) (LH/RH) using a suitable tool.





6.Remove the sun visor screws (A) (LH/RH).
7.Disconnect the harness connector from the sun visors (LH/RH) and remove.





8.Insert a suitable tool (A) at approximately a 30 degree angle into the sun visor holder notch on the front of the sun visor holder (1). Press in to release the locking tab (B). While holding in locking tab (B), turn the sun visor holder (1) 90 degrees to release it from the headliner.
- If the sun visor holder (1) does not fully rotate, make sure that the suitable tool (A) is pressing in on the locking tab (B) and is not positioned under locking tab (B). Reinsert the suitable tool (A) as necessary to release the locking tab (B).
-White arrow indicates : Front

CAUTION:
Do not force the sun visor holder when removing as the locking tab may be damaged if the suitable tool is not positioned correctly.





9.Remove all assist grips.
a.Disengage assist grip clip (1) using a suitable tool (A).
Slide assist grip clip forward and remove.
Broken triangle indicates : Clip

b.Slide assist grip (2) forward and remove.
10.Remove the front room/map lamp assembly. Refer to "Removal and Installation" Removal And Installation.
11.Partially remove the front body side welts (LH/RH). Refer to "BODY SIDE WELT : Removal and Installation Front Body Side Welt" Removal And Installation - Front Body Side Welt.
12.Partially remove the rear body side welts (LH/RH). Refer to "BODY SIDE WELT : Removal and Installation Rear Body Side Welt" Removal And Installation - Rear Body Side Welt.
13.Remove the windshield glass. Refer to "Removal and Installation" Removal And Installation.
14.Disconnect the harness connectors from the headlining, then remove the headlining through the windshield opening.

INSTALLATION

Installation is in the reverse order of removal.