Removal And Installation - Seat Assembly

FRONT SEAT

PASSENGER SIDE : Removal and Installation - Seat Assembly


REMOVAL


WARNING:
Do not leave any objects (screwdrivers, tools, etc.) on the seat during seat repair. It can lead to personal injury if the side air bag module should accidentally deploy.

CAUTION:
- When removing or installing the seat trim, handle it carefully to keep dirt out and to avoid damage.
- When checking the power seat circuit for continuity using a circuit tester, do not confuse its connector with the side air bag module connector. Such an error may cause the air bag module to deploy.
- Do not drop, tilt, or bump the side air bag module while installing the seat. Always handle it with care.
- After front side air bag module inflates, the front seatback assembly must be replaced.
- When removing and installing the seat, use shop cloths to protect components from damage.
- Before removing the front seat, turn the ignition switch OFF, disconnect both battery cables and wait at least three minutes.
1.Disconnect the negative and positive battery terminals and wait at least three minutes. Refer to "Removal and Installation (Battery)" Removal And Installation.
2.Remove the headrest.
3.Slide the seat to the full rearward position.





4.Remove the front slide covers (LH/RH) (A) by releasing four pawls on each.
Broken circle indicates : Pawl

5.Remove the two front seat bolts.
6.Slide the seat to the full forward position.
7.Remove the two rear seat bolts.
8.Tilt the seat rearward to disconnect the harness connectors from the seat and remove.

INSTALLATION

Installation is in the reverse order of removal.

WARNING:
- Perform additional services when installing front passenger seat. Refer to "ZERO POINT RESET : Description" Description.
- Zero point reset must be performed every time the front passenger seat is removed from the vehicle.
- Zero point reset is done after the front passenger seat is installed in vehicle and all bolts are tightened to specification.

CAUTION:
Make sure that the seat harness or the floor trim is not damaged during installation.





- When installing the RH front seat, tighten the bolts in the order shown.
RH front seat bolt torque: 49 Nm (5.0 kg-m, 36 lb-ft)