Removal And Installation

CVT SHIFT SELECTOR

Removal and Installation


CAUTION:
Always apply the parking brake before removal and installation.

REMOVAL

1.Apply the parking brake.

CAUTION:
Make sure the vehicle cannot move with the parking brake applied.
2.Disconnect battery negative terminal. Refer to "Removal and Installation (Battery)" Removal And Installation.





3.Remove shift lock override button cover (1) using suitable tool, and insert suitable tool into opening (A) to depress the shift lock override button. Move CVT shift selector to "N" position while depressing shift lock override button.
White arrow indicates : Front





4.Remove the shift selector handle (1).
a.Release the shift selector handle cover (2) using a suitable tool from the base of the shift selector handle (1).
b.Remove the shift selector handle clip (A).
c.Pull upward and remove the shift selector handle (1).
5.Remove the center console. Refer to "Removal and Installation" Removal And Installation.
6.Release the harness clip, then disconnect the harness connector from CVT shift selector.
7.Depress shift lock override button and move CVT shift selector to "P" position.
8.Remove the control cable from the CVT shift selector assembly. Refer to "Exploded View" Exploded View.
9.Remove the four CVT shift selector assembly nuts and the CVT shift selector assembly from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.





- When installing control cable (1) to the CVT shift selector assembly (2), check that control cable is fully pressed in until it stops with the ribbed surface (A) facing upward.
NOTE:
Apply multi-purpose grease to control cable eye before installation.
- Adjust control cable as necessary. Refer to "Inspection and Adjustment" CVT RE0F10D.