P0464

DTC P0464: Fuel Level Sensor Circuit Intermittent

Wiring Diagram:

Circuit Description
The Engine Control Module (ECM) uses the fuel level input from the Fuel Level Sensor to calculate expected vapor pressures within the fuel system. Vapor pressures vary as the fuel level changes. Vapor pressure is critical in determining if the Evaporative (EVAP) emission system is operating properly. Fuel level is also used to determine if the fuel level is too high or too low to be able to accurately detect EVAP emission system faults.

Conditions for Setting the DTC
- Ignition ON.
- Battery voltage is greater than 9.953 V.
- Gradient failure of the fuel tank lever sensor exists.

Action Taken When the DTC Sets
- The Malfunction Indicator Lamp (MIL) will illuminate.
- The ECM will record operating conditions at the time the diagnostic fail. This information will be stored in the Freeze Frame and Failure Records buffers.
- A history DTC is stored.

Conditions for Clearing the MIL/DTC
- The MIL will turn OFF at the end of a consecutive validation cycle in which the diagnostic runs without a fault.
- A history DTC will clear after 40 warm up cycles without a fault.
- DTC(s) can be cleared by using the scan tool.

Diagnostic Aids
If DTC P0463 is also displayed, go to DTC P0463 first. Inspect the wiring harness for damage. P0463

Inspect harness connectors for backed-out terminal, improper mating, broken locks, improperly formed or damaged terminals, and poor terminal-to-wire connection. Inspect the wiring harness for damage. A faulty fuel level sensor may cause the DTC to set. If DTC P0464 cannot be duplicated, the information included in the Freeze Frame data can be useful in determining vehicle operating conditions when the DTC was first set.

Test Description
The number(s) below refer to step(s) on the diagnostic table.
2. Determine if fault is present. Reviews Freeze Frame data to determine when the DTC set. Always record this information.

Step 1 - 2:

Step 3 - 12:

DTC Troubleshooting