Rear Power Window RH Does Not Operate With Rear Power Window Switch RH

WINDOW / GLASS: POWER WINDOW CONTROL SYSTEM: Rear Power Window RH does not Operate with Rear Power Window Switch RH
- Rear Power Window RH does not Operate with Rear Power Window Switch RH

DESCRIPTION

* If the manual up/down function does not operate, there may be a malfunction in the rear power window regulator switch, rear power window regulator motor RH, harness or connector.

WIRING DIAGRAM





INSPECTION PROCEDURE

PROCEDURE

1. CHECK LIN COMMUNICATION SYSTEM

(a) Check for LIN communication system DTCs related to the power window control system Reading and Clearing Diagnostic Trouble Codes.

OK:

LIN communication system DTCs are not output.

NG -- GO TO LIN COMMUNICATION SYSTEM LIN Communication System
OK -- Continue to next step.

2. CHECK FOR DTC (B2312)

(a) Check if DTC B2312 is output Reading and Clearing Diagnostic Trouble Codes.

OK:

DTC B2312 is not output.

NG -- GO TO DTC B2312 B2312
OK -- Continue to next step.

3. READ VALUE USING TECHSTREAM (REAR POWER WINDOW REGULATOR MOTOR RH)

(a) Use the Data List to check if the power window regulator motor is functioning properly Scan Tool Testing and Procedures.

RR-Door Motor





OK:

The Techstream display changes according to operation of the rear power window switch RH.

NG -- CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)

OK -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal

4. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - BODY GROUND)

(a) Disconnect the J3 switch connector.





(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

5. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR MOTOR RH - BATTERY AND BODY GROUND)

(a) Disconnect the J4 motor connector.





(b) Measure the voltage and resistance according to the value(s) in the table below.

Standard Voltage:





Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

6. CHECK HARNESS AND CONNECTOR (REAR POWER WINDOW REGULATOR SWITCH RH - REAR POWER WINDOW REGULATOR MOTOR RH)

(a) Disconnect the J3 switch connector.





(b) Disconnect the J4 motor connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- Continue to next step.

7. INSPECT REAR POWER WINDOW REGULATOR SWITCH RH





(a) Remove the rear power window regulator switch RH Removal.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:





NG -- REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY RH Removal

OK -- REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH Removal