Installation

3UR-FE BATTERY / CHARGING: GENERATOR: INSTALLATION

1. INSTALL GENERATOR ASSEMBLY (for 130 A, 150 A Type)

(a) Install the generator with the 3 bolts and nut.





Torque : 43 Nm (438 kgf-cm, 32 ft-lbf)

(b) Connect the generator connector.





(c) Connect the generator wire with the nut.

Torque : 9.8 Nm (100 kgf-cm, 87 in-lbf)

(d) Install the terminal cap.

(e) Install the harness bracket to the generator with the bolt.

Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

2. INSTALL GENERATOR ASSEMBLY (for 180 A Type)

(a) Install the generator with the 3 bolts and nut.





Torque : 43 Nm (438 kgf-cm, 32 ft-lbf)

(b) Connect the generator connector.





(c) Connect the generator wire with the nut.

Torque : 12 Nm (122 kgf-cm, 9 ft-lbf)

(d) Install the terminal cap.

(e) Install the harness bracket to the generator with the bolt.

Torque : 31 Nm (316 kgf-cm, 23 ft-lbf)

3. CONNECT VANE PUMP ASSEMBLY





HINT
Before performing the following procedures, move the spacer until the vane pump can be installed.

(a) Install the vane pump to the timing chain cover with the 2 bolts.





Torque : 28 Nm (286 kgf-cm, 21 ft-lbf)

(b) Connect the clamp and 2 power steering connectors.





4. INSTALL FRONT FENDER APRON SEAL RH Installation

5. INSTALL FAN SHROUD Installation

6. CONNECT OUTLET RADIATOR HOSE Installation

7. INSTALL INLET RADIATOR HOSE Installation

8. ADD ENGINE COOLANT Service and Repair

9. INSPECT FOR COOLANT LEAK Testing and Inspection

10. INSTALL V-BANK COVER SUB-ASSEMBLY Installation

11. INSTALL NO. 1 ENGINE UNDER COVER Replacement

12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 5.4 Nm (55 kgf-cm, 48 in-lbf)

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.