Removal
U660F AUTOMATIC TRANSMISSION / TRANSAXLE: SHIFT LEVER: REMOVAL
1. REMOVE FRONT DOOR SCUFF PLATE RH Removal
2. REMOVE FRONT DOOR SCUFF PLATE LH Removal
3. REMOVE COWL SIDE TRIM BOARD RH Removal
4. REMOVE COWL SIDE TRIM BOARD LH Removal
5. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
6. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
7. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL Removal
8. REMOVE KNEE AIRBAG ASSEMBLY Removal
9. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal
10. REMOVE GLOVE COMPARTMENT DOOR SUB-ASSEMBLY Removal
11. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
12. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY Removal
13. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Automatic Air Conditioning System) Removal
14. REMOVE AIR CONDITIONING CONTROL ASSEMBLY (for Manual Air Conditioning System) Removal
15. REMOVE CONSOLE BOX ASSEMBLY (for Fixed Type)
Removal
16. REMOVE CONSOLE BOX ASSEMBLY (for Slide Type)
Removal
17. REMOVE LOWER CENTER INSTRUMENT COVER (w/ Console Box) Removal
18. REMOVE LOWER CENTER INSTRUMENT COVER (w/o Console Box) Removal
19. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY Removal
20. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal
21. REMOVE INSTRUMENT PANEL FINISH PANEL END LH Removal
22. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY Removal
23. REMOVE SHIFT LEVER ASSEMBLY
(a) Move the shift lever to N.
(b) Disconnect the shift lock control ECU connector and transmission control switch wire connector.
(c) Remove the 4 nuts and shift lever.
24. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Disconnect the end of the transmission control cable from the shift lever.
(b) Using a screwdriver, pull out the transmission control cable stopper.
NOTICE:
Do not remove the stopper. If the stopper is removed, reinstall it to its original position.
(c) Rotate the nut counterclockwise approximately 270° and, while holding the nut in that position, disconnect the transmission control cable from the shift lever retainer.
