Installation

A340E AUTOMATIC TRANSMISSION: VALVE BODY ASSEMBLY: INSTALLATION

1. INSTALL TRANSMISSION VALVE BODY ASSEMBLY





(a) Install the shift solenoid valve SLU with the bolt.

Torque : 6.4 Nm (65 kgf-cm, 56 in-lbf)

(b) Install the shift solenoid valves S1 and S2 with the bolt.

Torque : 6.4 Nm (65 kgf-cm, 56 in-lbf)

(c) Install the shift solenoid valve SLT with the bolt.

Torque : 6.4 Nm (65 kgf-cm, 56 in-lbf)

(d) Align the groove of the manual valve with the pin of the lever.





(e) Install the 20 bolts.





Torque : 11 Nm (110 kgf-cm, 8 ft-lbf)

Bolt length:

Bolt A: 23 mm (0.91 in.)

Bolt B: 28 mm (1.10 in.)

Bolt C: 36 mm (1.42 in.)

2. INSTALL TRANSMISSION WIRE Installation

3. INSTALL VALVE BODY OIL STRAINER ASSEMBLY





(a) Install 5 new gaskets.

(b) Install the oil strainer with the 4 bolts.





Torque : 10 Nm (100 kgf-cm, 7 ft-lbf)

Bolt length:

Bolt A: 14 mm (0.55 in.)

Bolt B: 20 mm (0.79 in.)

Bolt C: 23 mm (0.91 in.)

4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY





HINT
Remove any packing material and be careful not to drop oil on the contact surfaces of the transmission case and oil pan sub-assembly.

(a) Install the 3 magnets onto the oil pan sub-assembly, in the portions indicated in the illustration.

(b) Apply seal packing to the oil pan, as shown in the illustration.





Seal packing:

Toyota Genuine Seal Packing 1281, Three Bond 1281 or equivalent Seal

Seal diameter
2 to 3 mm (0.0787 to 0.118 in.)

(c) Install the oil pan sub-assembly with the 19 bolts.

Torque : 7.4 Nm (75 kgf-cm, 65 in-lbf)

5. INSTALL TRANSMISSION OIL FILLER TUBE SUB-ASSEMBLY Installation

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque : 3.9 Nm (40 kgf-cm, 35 in-lbf)

7. ADD AUTOMATIC TRANSMISSION FLUID

8. INSPECT AUTOMATIC TRANSMISSION FLUID A340E Automatic Transmission

9. INSPECT FOR AUTOMATIC TRANSMISSION FLUID LEAK