Selector Mechanism Cover and Circuit Board

Selector Mechanism Cover and Circuit Board

Removing

- Remove selector lever handle => [ Selector Lever Handle ] Selector Lever Handle.

- Switch ignition off.

- Remove center console.

- Disconnect harness connector from circuit board.

- Carefully pry off frame - 1 - at four corners - arrows - and remove.





If retaining tabs - arrows - are damaged, cover must be replaced completely.

- Remove complete shift mechanism cover upward.

- Remove circuit board from mounts on frame - arrows -.





Installing

• When installing circuit board, make sure that the terminals are not damaged and circuit board is not kinked.

- Install circuit board on to mounts on frame - arrows -.





- Carefully place cover - 1 - on selector mechanism and lock with retaining straps - arrows - (qty. 4).





If retaining straps - arrows - are damaged, cover must be replaced completely.

- Connect harness connector from circuit board.

- Install center console.

- Install selector lever handle => [ Selector Lever Handle ] Selector Lever Handle.