Shift Solenoid: Service and Repair

Solenoid Valve and Sensor Wiring Harness

Removing

- Drain the Automatic Transmission Fluid (ATF). Refer to => [ Automatic Transmission Fluid, Draining and Filling ] Automatic Transmission Fluid, Draining and Filling.

- Remove the valve body. Refer to => [ Valve Body ] Valve Body.

- Disconnect the connector from the transmission.

- 1 - transmission sensor terminal

- 2 - connector for solenoid valves





- Disconnect the connector housing from the transmission.

- Disconnect the connector housing together with the wiring harness outward from the transmission housing.

Installing

- Replace the seal on the connector housing.

- Carefully guide the wiring harness from the outside into the transmission.

- Lubricate the connector housing seal with ATF and then press the connector housing all the way into the transmission.

- Connect the connector housing. Tightening specification, refer to => [ Fastener Tightening Specifications ] Fastener Tightening Specifications - Gears, Hydraulic Controls.

- Install the valve body. Refer to => [ Valve Body ] Valve Body.

- Add the ATF, check the ATF level and top off if necessary. Refer to => [ Automatic Transmission Fluid Level, Checking and Filling ] Automatic Transmission Fluid Level, Checking and Filling.