Removal and Replacement

Selector Lever Cable

• Following installation, cable must be checked for ease of movement and be adjusted.

Removing

- Move selector lever to position "S" position.

- Lever cable - 1 - off lever - 3 - using an open wrench - 2 -.





- Press catches together - arrows - and remove cable from cable support bracket.

- Raise vehicle.

To remove cable and/or selector mechanism, heat shield and, if necessary, parts of exhaust system must now be removed (Gasoline engines)

- Remove heat shield.

- Remove - selector housing - beneath selector lever.





In order to remove cable, - pin - must be pressed up with a - screwdriver -.

- At the same time, press forward securing tab holding - pin - - arrows -.

- Remove securing clip. Always replace securing clip.

- Remove selector lever cable.

Installing

- Loosen adjusting screw of cable.

Do not grease cable.

- Route selector lever cable free of tension, insert in support bracket on transmission but do not secure yet.

- Also clip cable into retainer. Ensure that retainer does not contact oil cooler.

- Nuts - 8 Nm





- Secure cable to selector lever using pin and secure to support bracket of selector mechanism using new securing clip.

- Install selector housing, heat shield and exhaust system.

- After installing, check cable --> [ Selector Lever Cable, Checking ] Procedures.