Oil Cooler: Service and Repair

Oil Cooler

Removing

- Drain the cooling system. Refer to => [ Cooling System Draining and Filling ] Cooling System Draining and Filling.

- Raise and suitably support the vehicle.






- Reposition the coolant inlet hose (7) and outlet hose (6) clamps at the oil cooler.

- Remove the coolant inlet hose (7) and outlet hose (6) from oil cooler.

- Remove the oil filter (1).

- Remove the oil cooler bolt (2) from the oil cooler (3).

- Remove the oil cooler (3).

Installing






- Lubricate the seal and position the oil cooler (3) so that the notch of the oil cooler is aligned to the notch on oil pan (8).

• Position the flat side of oil cooler parallel to oil pan rail.

- Position the oil cooler to the engine block.

- Install the oil cooler bolt (2). Tighten the bolt to 54 Nm (40 ft lbs).

- Install the oil filter (1).

- Connect the coolant inlet coolant hose (7) and outlet hose (6) to oil cooler (3).

- Position the coolant inlet hose (7) and outlet hose (6) clamps at the oil cooler.

- Fill the cooling system. Refer to => [ Cooling System Draining and Filling ] Cooling System Draining and Filling.