Shift Handle With Cover

Shift Handle with Cover

• For all shift handles, there is the possibility that the button can be pushed into the handle. Do not install the handle with the button pushed in. Refer to => [ Shift Handle with Cover ] Shift Handle With Cover.

- Pull the button out beyond its press point before removing.





- Secure the button from being pressed in using a tie strap or wire.

- Unclip the cover.

- Push the sleeve upward and unlock the handle.





The locking button for the GTI/Golf handle must not be pushed in.





- If this should happen anyway, unclip the handle trim upward.





- Press the small lever for the cable rod - arrow - again into the groove before the handle is installed.

- Lock the handle again after installing it. To do this, press the sleeve under the handle.

- With new handles, only the transportation safeguard has to be removed. The locking button is already in the installed position.





- Disconnect the connector from the cover.

- Pull off the handle upward.

- Lock the handle again after installing it. Push the sleeve under the handle.