Shift Unit Overview

Shift Unit Overview






1 Shift Unit

• Consisting of the gear shift shaft and the gear shift cover.

• The components cannot be separated from each other.

2 Backup Lamp Switch (F4)

• 20 Nm

• Coat the tab lightly with MoS 2 grease.

3 Locking Pin

• For adjusting the shift mechanism.

• Removing, refer to => [ Removing the Locking Pin from the Gear Shift Cover ] Shift Unit.

• Installing, refer to => [ Pressing the Locking Pin into the Gear Shift Cover ] Shift Unit.

4 Relay Lever

• With a cable retainer.

• Installed position, refer to => [ Transmission Shift Lever/Relay Lever, Installed Position ] Shift Mechanism Overviews.

• Lubricate before installing, refer to => [ Relay Lever, Lubricating ] Shift Mechanism Overviews.

5 Clip

• Secures the relay lever in the gear shift cover.

6 Seal

• Pry out with a screwdriver.

• Installing, refer to => [ Install the Seal Completely ] Shift Unit.

7 Nut

• 23 Nm

• Always replace.

• Self locking.

8 Transmission Shift Lever

• Insert so that the master spline aligns with the shift rod. Refer to => [ Installing the Transmission Shift Lever ] Shift Unit.

• Can be replaced with the gear shift unit still installed.

• Installed position, refer to=> [ Transmission Shift Lever/Relay Lever, Installed Position ] Shift Mechanism Overviews.

9 Cap

• For transmission ventilation.

10 Sealing Cap

11 Spring

• Not installed in all transmissions.

• Install if present.