Removal

CRUISE CONTROL: DRIVING SUPPORT ECU: REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
* w/ Navigation System:
After the engine switch is turned off, the display and navigation module display (navigation system) records various types of memory and settings. As a result, after turning the engine switch off, be sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal:





* When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

2. REMOVE DOOR SCUFF PLATE ASSEMBLY RH Removal

3. REMOVE COWL SIDE TRIM BOARD RH Removal

4. REMOVE INSTRUMENT PANEL FINISH PANEL END RH Removal

5. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Removal

6. REMOVE LOWER INSTRUMENT COVER LH Removal

7. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY Removal

8. REMOVE INSTRUMENT SIDE PANEL RH Removal

9. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH Removal

10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY Removal

11. REMOVE INSTRUMENT PANEL BOX DOOR COVER Removal

12. REMOVE INSTRUMENT PANEL BOX ASSEMBLY Removal

13. REMOVE DCM (TELEMATICS TRANSCEIVER) Removal

14. REMOVE NO. 2 AIR DUCT SUB-ASSEMBLY Removal

15. REMOVE ECU INTEGRATION BOX RH Removal

16. REMOVE DRIVING SUPPORT ECU ASSEMBLY





(a) Detach the claw and remove the driving support ECU assembly.