Installation

EXTERIOR: FRONT BUMPER: INSTALLATION

INSTALLATION

1. INSTALL FRONT BUMPER BAR REINFORCEMENT LH
(a) Install the bumper bar reinforcement with the 2 screws.
2. INSTALL FRONT BUMPER BAR REINFORCEMENT RH
HINT: Use the same procedures described for the LH side.

3. INSTALL FRONT BUMPER SIDE RETAINER LH
(a) Attach the claw to install the retainer, and then install the screw.
4. INSTALL FRONT BUMPER SIDE RETAINER RH
HINT: Use the same procedures described for the LH side.

5. INSTALL RADIATOR SUPPORT OPENING COVER
(a) Install the radiator support opening cover with the 2 clips.

6. INSTALL FRONT LOWER SUSPENSION CROSSMEMBER
(a) Install the suspension crossmember with the 4 bolts and 3 clips.
Torque: 25 Nm (255 kgf-cm, 18ft-lbf)

7. INSTALL FRONT LOWER BUMPER ABSORBER
(a) Install the absorber.

8. INSTALL FRONT BUMPER REINFORCEMENT
(a) Install the reinforcement with the 6 bolts.
Torque: 29 Nm (296 kgf-cm, 21ft-lbf)
(b) Connect the cooler thermistor connector.
(c) Install the height control cleaner to the reinforcement.
(d) w/ Headlight Cleaner System:
Attach the 4 headlight cleaner hose clamps.

9. INSTALL FRONT BUMPER ENERGY ABSORBER
(a) Install the energy absorber.
10. INSTALL FRONT BUMPER COVER
(a) Connect the 2 fog light connectors and No. 4 engine room main wire connector and install the front bumper.

(b) Attach the 6 claws to the connect the front bumper, as shown in the illustration.
HINT: Use the same procedures for the RH side and LH side.

(d) Install the 8 screws.

11. INSTALL FRONT FENDER LINER LH
(a) Install the 2 clips so that their grooves are vertical.
12. INSTALL FRONT FENDER LINER RH
HINT: Use the same procedures described for the LH side.

13. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
(a) Install the extension pad with the 5 screws and clip.
14. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
HINT: Use the same procedures described for the LH side.

15. INSTALL FRONT FENDER WHEEL OPENING MOULDING LH
16. INSTALL FRONT FENDER WHEEL OPENING MOULDING RH
HINT: Use the same procedures described for the LH side.

17. INSTALL RADIATOR GRILLE ASSEMBLY Installation
18. INSTALL COOL AIR INTAKE DUCT SEAL Installation
19. INSTALL INLET AIR CLEANER COVER SUB-ASSEMBLY Installation
20. INSTALL ENGINE ROOM SIDE COVER LH Installation
21. INSTALL ENGINE ROOM SIDE COVER RH Installation
22. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

23. INSTALL BATTERY SERVICE HOLE COVER LH Installation
24. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation