Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY: INSTALLATION

INSTALLATION
HINT:
- Use the same procedures for the LH side and RH side.
- The procedures listed below are for the LH side.

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY
(a) Install the curtain shield airbag with the 2 clips and 8 bolts.
Torque: 11 Nm (110 kgf-cm, 8ft-lbf)




NOTICE:
Do not twist the curtain shield airbag when installing it.

(b) Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.

2. INSTALL ROOF HEADLINING ASSEMBLY
(a) Refer to the procedures from "INSTALL ROOF HEADLINING ASSEMBLY" Installation.
3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected Repair Instruction - Initialization.

4. INSTALL BATTERY SERVICE HOLE COVER LH Installation
5. INSTALL DECK TRIM SIDE BOARD LH (w/o Spare Tire) Installation
6. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY Installation
7. CHECK SRS WARNING LIGHT
(a) Check the SRS warning light Pinout Values and Diagnostic Parameters.