Operation CHARM: Car repair manuals for everyone.

Installation





SLIDING ROOF: SLIDING ROOF HOUSING (for Standard): INSTALLATION

1. INSTALL SLIDING ROOF WEATHERSTRIP

(a) Install the sliding roof weatherstrip as follows:

(1) Position the joint of the weatherstrip at the rear center.

(2) Align the marks on the weatherstrip with the middle marks at the corners of the plastic on the edge of the sliding roof panel and install the weatherstrip. Make sure that the marks on the weatherstrip are positioned within the area indicated by the marks at the corners of the plastic on the edge of the sliding roof panel.

(3) Install the lip of the weatherstrip firmly.





2. INSTALL SLIDING ROOF HOUSING SUB-ASSEMBLY

(a) Install the sliding roof housing sub-assembly with the 8 bolts and 8 nuts.





Nut - Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

Bolt - Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)

(b) Connect the 4 sliding roof drain hoses.





NOTICE:
The clip must face toward the outside of the vehicle and also be above the lower surface of the sliding roof housing when installing the drain hoses.

3. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY

(a) Using a T25 "TORX" socket wrench, temporarily install the sliding roof glass sub-assembly with the 4 screws.





(b) Perform a level check.





(1) Check the difference in level at "a", between the roof panel and the upper surface of the weatherstrip, when the sliding roof glass is fully closed.

Standard:





HINT
"+" represents the condition that the glass is above the panel level. "-" represents the condition that the glass is below the panel level.

(c) Perform a gap check.





(1) Check the gap between the roof panel and roof glass.

NOTICE:
The gap must be even all around.

(d) After adjusting the sliding roof glass, using a T25 "TORX" socket wrench, install the sliding roof glass sub-assembly with the 4 screws.

Torque : 5.5 Nm (56 kgf-cm, 49 in-lbf)

4. INSPECT FOR WATER LEAKS

(a) After adjusting the sliding roof glass sub-assembly, inspect for water leaks.

(b) If there are any leaks, readjust the sliding roof glass sub-assembly.

5. INSTALL SLIDING ROOF SIDE GARNISH LH

(a) Engage the 5 claws and install the sliding roof side garnish LH.





6. INSTALL SLIDING ROOF SIDE GARNISH RH

HINT
Use the same procedure for the RH side and LH side.

7. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH Installation

8. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT
Use the same procedure for the RH side and LH side.

9. INSTALL ROOF HEADLINING ASSEMBLY Installation

10. INSTALL ASSIST GRIP SUB-ASSEMBLY Installation

11. INSTALL INTERIOR ILLUMINATION LIGHT ASSEMBLY Installation

12. INSTALL SPOT LIGHT ASSEMBLY LH Installation

13. INSTALL SPOT LIGHT ASSEMBLY RH Installation

14. INSTALL VISOR HOLDER Installation

15. INSTALL VISOR ASSEMBLY LH Installation

16. INSTALL VISOR ASSEMBLY RH Installation

17. INSTALL VISOR BRACKET COVER Installation

18. INSTALL ROOF CONSOLE BOX ASSEMBLY Installation

19. INSTALL RAIN SENSOR COVER Installation

20. INSTALL INNER REAR VIEW MIRROR STAY HOLDER COVER Installation

21. INSTALL FLOOR CARPET BRACKET LH

22. INSTALL FLOOR CARPET BRACKET RH

23. INSTALL SHIFT LEVER ASSEMBLY Installation

24. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY Installation

25. INSTALL NO. 2 CONSOLE BOX DUCT Installation

26. INSTALL NO. 3 CONSOLE BOX DUCT Installation

27. INSTALL REAR CONSOLE BOX ASSEMBLY Installation

28. INSTALL CONSOLE REAR END PANEL SUB-ASSEMBLY Installation

29. INSTALL CONSOLE BOX CARPET Installation

30. INSTALL CONSOLE BOX POCKET Installation

31. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/o Seat Heater System) Installation

32. INSTALL HEATER SEAT SWITCH CONSOLE BASE (w/ Seat Heater System) Installation

33. INSTALL UPPER CONSOLE PANEL ASSEMBLY WITH FRONT ASH RECEPTACLE Installation

34. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY Installation

35. INSTALL INSTRUMENT PANEL FINISH PANEL END LH Installation

36. INSTALL INSTRUMENT PANEL FINISH PANEL END RH Installation

37. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH Installation

38. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY LH Installation

39. INSTALL UPPER CENTER PILLAR GARNISH LH Installation

40. INSTALL LOWER CENTER PILLAR GARNISH LH Installation

41. INSTALL REAR DOOR SCUFF PLATE LH Installation

42. INSTALL FRONT PILLAR GARNISH LH Installation

43. INSTALL SIDE INSTRUMENT PANEL LH Installation

44. INSTALL FRONT DOOR OPENING TRIM COVER LH Installation

45. INSTALL FRONT DOOR SCUFF PLATE LH Installation

46. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY RH Installation

47. INSTALL REAR SEAT SIDE AIRBAG ASSEMBLY RH Installation

48. INSTALL UPPER CENTER PILLAR GARNISH RH Installation

49. INSTALL LOWER CENTER PILLAR GARNISH RH Installation

50. INSTALL REAR DOOR SCUFF PLATE RH Installation

51. INSTALL FRONT PILLAR GARNISH RH Installation

52. INSTALL SIDE INSTRUMENT PANEL RH Installation

53. INSTALL FRONT DOOR OPENING TRIM COVER RH Installation

54. INSTALL FRONT DOOR SCUFF PLATE RH Installation

55. INSTALL FRONT SEAT ASSEMBLY LH Installation

56. INSTALL FRONT SEAT REAR OUTER TRACK BRACKET COVER LH Installation

57. INSTALL FRONT SEAT REAR INNER TRACK BRACKET COVER LH Installation

58. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER LH Installation

59. INSTALL FRONT SEAT INNER TRACK BRACKET COVER LH Installation

60. CONNECT FRONT SEAT OUTER BELT ASSEMBLY LH Installation

61. INSTALL SEAT BELT ANCHOR COVER CAP LH Installation

62. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Driver Seat)

63. INSTALL FRONT SEAT ASSEMBLY RH Installation

64. INSTALL FRONT SEAT REAR OUTER TRACK BRACKET COVER RH Installation

65. INSTALL FRONT SEAT REAR INNER TRACK BRACKET COVER RH Installation

66. INSTALL FRONT SEAT OUTER TRACK BRACKET COVER RH Installation

67. INSTALL FRONT SEAT INNER TRACK BRACKET COVER RH Installation

68. CONNECT FRONT SEAT OUTER BELT ASSEMBLY RH Installation

69. INSTALL SEAT BELT ANCHOR COVER CAP RH Installation

70. INSTALL FRONT SEAT HEADREST ASSEMBLY (for Front Passenger Seat)

71. INSTALL REAR SEATBACK ASSEMBLY Installation

72. INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

73. INSTALL REAR SEAT HEADREST ASSEMBLY

74. INSTALL REAR SEAT CUSHION ASSEMBLY Installation

75. PERFORM INITIALIZATION

NOTICE:
Some systems need initialization after reconnecting the cable to the negative battery terminal Repair Instruction - Initialization.

76. RESET SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY

Initialization

77. INSPECT SLIDING ROOF SYSTEM

On-Vehicle Inspection

78. INSPECT SHIFT LEVER POSITION Adjustments

79. ADJUST SHIFT LEVER POSITION Adjustments

80. INSPECT FRONT SEAT ASSEMBLY Installation

81. INSPECT SRS WARNING LIGHT

Diagnosis System