GPS Antenna Feeder Removal/Installation

GPS ANTENNA FEEDER REMOVAL/INSTALLATION

CAUTION:
- If the GPS antenna feeder is installed with tension on the cable and wiring harness it could result in loosening of the connection areas and poor contact. When installing and connecting the GPS antenna feeder, always make sure there is slack on the cable and wiring harness.

NOTE:
- The GPS antenna feeder is integrated with the vehicle wiring harness.

1. Disconnect the negative battery cable.

2. Remove the following parts:
a. Front door Front Door Removal/Installation

b. Sail garnish Service and Repair

c. Front scuff plate inner Front Scuff Plate Removal/Installation

d. Front side trim Front Side Trim Removal/Installation

e. Side panel (passenger's side) Side Panel Removal/Installation

f. Side wall Side Wall Removal/Installation

g. Front console Front Console Removal/Installation

h. Glove compartment Service and Repair

i. Lower panel Lower Panel Removal/Installation

j. Center panel module (vehicles with audio unit) Center Panel Module Removal/Installation

k. Center panel (vehicles without audio unit) Center Panel Removal/Installation

l. Climate control unit Climate Control Unit Removal/Installation [Full-Auto Air Conditioner] Climate Control Unit Removal [Manual Air Conditioner] Climate Control Unit Installation [Manual Air Conditioner]

m. Car-navigation unit (Vehicles with car-navigation system) Service and Repair

n. Selector lever component Service and Repair

o. Meter hood Meter Hood Removal/Installation

p. Lower column cover Service and Repair

q. Driver-side air bag module Driver-Side Air Bag Module Removal/Installation

r. Steering shaft Service and Repair

s. Instrument cluster Removal and Replacement

t. A-pillar trim A-Pillar Trim Removal/Installation

u. Rear heater duct (1) Service and Repair

v. Windshield wiper arm and blade Windshield Wiper Arm And Blade Removal/Installation

w. Cowl grille Cowl Grille Removal/Installation

x. Center cowl grille Center Cowl Grille Removal/Installation

y. Dashboard Dashboard Removal/Installation

3. Secure the new GPS antenna feeder to the vehicle wiring harness along the installation route of the old GPS antenna feeder.