Heater Core Case: Service and Repair

AIRFLOW MODE MAIN LINK REMOVAL/INSTALLATION

1. Remove the battery cover. Removal and Replacement

2. Disconnect the negative battery cable.

3. Removal the following parts.
a. Side wall Side Wall Removal/Installation

b. Shift lever component (MTX) Service and Repair

c. Selector lever component (ATX) Service and Repair

d. Front console Front Console Removal/Installation

4. Detach the hood release lever from the lower panel. (See Service and Repair.)

5. Remove the front scuff plate. (LH) (See Front Scuff Plate Removal/Installation.)

6. Remove the front side trim. (LH) (See Front Side Trim Removal/Installation.)

7. Remove the lower panel. Lower Panel Removal/Installation

8. Remove the column cover Service and Repair

9. Remove the shower duct (LH).

10. Remove the airflow mode rod (1).

11. Remove the airflow mode actuator. Airflow Mode Actuator Removal/Installation [Full-Auto Air Conditioner] (Full-auto air conditioner)

12. Remove the airflow mode main link.






13. Install in the reverse order of removal.

Airflow Mode Main Link Installation Note

CAUTION:
- Apply only the specified grease to links. Otherwise abnormal noise or improper operation may result.

1. Push and hold each airflow mode sub link in the direction of the arrow.






2. Set the airflow mode main link to the A/C unit as shown in the figure.

3. Press the airflow mode main link lightly to the A/C unit it in the direction shown by the arrow, then set the projections of each airflow mode sub link into the grooves of the airflow mode main link.

4. Rotate airflow mode main link and verify that each mode is accessed properly.