Courtesy Lamp: Service and Repair
INTERIOR LIGHT REMOVAL/INSTALLATION
1. Remove the battery cover. Removal and Replacement
2. Disconnect the negative battery cable.
3. Remove the following parts:
a. A-pillar trim A-Pillar Trim Removal/Installation
b. Front scuff plate inner Front Scuff Plate Removal/Installation
c. Rear scuff plate Rear Scuff Plate Removal/Installation
d. B-pillar lower trim B-Pillar Lower Trim Removal/Installation
e. Front seat belt upper anchor installation bolt Front Seat Belt Removal/Installation
f. B-pillar upper trim B-Pillar Upper Trim Removal/Installation
g. Rear package tray lid Service and Repair
h. Sub-trunk Service and Repair
i. Third-row seat Third-Row Seat Removal/Installation
j. Rear header trim Rear Header Trim Removal/Installation
k. Trunk end trim Trunk End Trim Removal/Installation
l. Third-row seat belt lower anchor installation bolt Third-Row Seat Belt Removal/Installation
m. Cargo compartment light Service and Repair
n. Trunk side trim
o. Second-row seat belt upper anchor installation bolt Second-Row Seat Belt Removal/Installation
p. C-pillar trim C-Pillar Trim Removal/Installation
q. Map light Service and Repair
r. Assist handle Service and Repair
s. Sunvisor Service and Repair
t. Headliner Headliner Removal/Installation
4. Detach the tab and remove the bulb housing.
NOTE:
- The valve housing and the wiring harness have been integrated and attached to the headliner. The wiring harness passes under the urethane and shock absorption pad, so if the valve housing is to be replaced, cut the urethane and then cut and remove the shock absorption pad.
5. Pull in the direction of the arrows and detach the tabs.
6. Remove the interior light.
7. Install in the reverse order of removal.
NOTE:
- Install a new shock absorption pad by applying adhesive to the areas where the previous shock absorption pad was removed after installing the wiring harness. Also, after installing the wiring harness and shock absorption pad, reinforce the areas where the urethane was cut with vinyl tape.