Shift-Lock System Inspection

SHIFT-LOCK SYSTEM INSPECTION

Shift-Lock System Inspection

1. Switch the ignition to ON.

2. Shift the selector lever to the P position.

3. Perform the following procedures to inspect the shift-lock system.

- If there is any malfunction, inspect the shift-lock solenoid.

a. Verify that the selector lever cannot be selected from P to R position when the brake pedal is released.

b. Verify that the selector lever can be selected from P to R position when the brake pedal is depressed.

Shift-Lock Solenoid Inspection

CAUTION:
- Water or foreign objects entering the connector can cause a poor connection or corrosion. Be sure not to drop water or foreign objects on the connector when disconnecting it.

1. Disconnect the selector lever component connector.
a. Disconnect the negative battery cable.

b. Remove the rear console. Rear Console Removal/Installation

c. Disconnect the selector lever component connector.






2. According to the table, measure the voltage between selector lever component terminals and body GND.






- If there is any malfunction, repair or replace the related wiring harness.
- If there is no malfunction, replace the selector lever component. Automatic Transaxle Shift Mechanism Removal/Installation

Shift-lock solenoid specification





Emergency Override Button Inspection

1. Switch the ignition to off.

2. Verify that the selector lever is in the P position.

3. Without the brake pedal depressed, verify that the selector lever cannot be shifted from the P position.

4. Remove the panel cover using a tape-wrapped flathead screwdriver as shown in the figure.






5. Insert the flathead screwdriver into the emergency override hole and push it down.

6. Verify that the selector lever can be shifted from the P position.

- If there is any malfunction, replace the selector lever component. Automatic Transaxle Shift Mechanism Removal/Installation