C1300
C1300Description
The brake ECU outputs this DTC malfunctions are found in the circuit inside the computer by self diagnosis.
C1300:
Diagnosis Procedure
CAUTION:
When replacing the brake ECU, perform initialization of linear solenoid valve and calibration.
1.REPLACE BRAKE ECU
Replace the brake ECU.
>> INSPECTION END
Special Repair Requirement
1.ZERO ADJUSTMENT FOR EACH SENSOR AND OFFSET LEANING FOR LINEAR SOLENOID VALVE
After erasing brake ECU memories, perform zero adjustment of following sensors and initialization of linear solenoid valve.
^ Steering angle sensor: BRC-9, "PERFORM ZERO POINT OF STEERING ANGLE SENSOR: Description". Testing and Inspection
^ Yaw rate/side/decel G sensor: BRC-8, "PERFORM ZERO POINT OF YAW RATE/SIDE/DECEL G SENSOR: Description". Testing and Inspection
^ Brake stroke sensor: BRC-9, "PERFORM ADJUSTMENT OF STROKE SENSOR: Description". Perform Adjustment of Stroke Sensor
^ Linear solenoid valve: BRC-7, "PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE AND CALIBRATION: Description". Perform Initialization of Linear Solenoid Valve and Calibration
>> END