Removal And Installation

FLOOR TRIM


Removal and Installation


REMOVAL
1. Remove the seat assembly (LH/RH). Refer to Removal And Installation.
2. Remove accelerator pedal pad. Refer to Removal and Replacement.





3. Disengage clip of floor hook (1) with remover tool (A).

4. Remove foot grille. Refer to Foot Grille.
5. Remove the seat belt floor anchor bolt (LH/RH). Refer to Exploded View.
6. Remove center console assembly. Refer to Removal And Installation.
7. Remove instrument lower cover (LH/RH), glove box assembly, instrument lower panel RH and instrument side panel (LH/RH). Refer to Removal And Installation.
8. Remove seatback center finisher. Refer to Removal And Installation.





9. Disconnect the harness connector (A), (B), (C) and (D) from the diagnosis sensor unit (1) and then remove the clips fixing the harness to the floor trim as shown in the figure.

10. Remove console panel (LH/RH). Refer to Removal And Installation.
11. Remove the kicking plate inner (LH/RH), dash side finisher (LH/RH) and body side welt (LH/RH). Refer to Removal And Installation.
12. Remove floor trim fixing clips.
13. Remove floor trim from floor trim fixing clips and remove floor trim.

INSTALLATION
Install in the reverse order of removal.