Transmission Position Sensor/Switch: Service and Repair

ON-VEHICLE SERVICE


Park/Neutral Position (PNP) Switch


COMPONENTS






REMOVAL AND INSTALLATION

Removal
1. Disconnect the battery negative terminal.
2. Remove air duct (inlet). Refer to Service and Repair Service and Repair.





3. Remove control cable (1) from manual shaft. Refer to Removal and Replacement.
4. Disconnect PNP switch harness connector (2).
5. Remove PNP switch bolts.
6. Set manual shaft in "P" position.
7. Remove PNP switch from A/T.

Installation
Installation is in the reverse order of removal.

NOTE:
- Align PNP switch position when installing.
- After installation is completed, adjust and check the PNP switch and A/T position. Refer to "PARK/NEUTRAL POSITION (PNP) SWITCH ADJUSTMENT", Adjustments and Testing and Inspection.
- After installation is completed, check continuity of PNP switch. Refer to Component Inspection.

PARK/NEUTRAL POSITION (PNP) SWITCH ADJUSTMENT
1. Remove air duct (inlet). Refer to Service and Repair Service and Repair.





2. Set selector lever and manual shaft (1) in "N" position.
3. Remove control cable from manual shaft (1). Refer to Removal and Replacement.
4. Loosen PNP switch bolts.
:Bolt
5. Insert the pin (3) [4 mm (0.16 in) dia.] straight into manual shaft
(1) adjustment hole.
6. Rotate PNP switch (2) until the pin (3) can also be inserted straight into hole in PNP switch (2).
7. Tighten PNP switch bolts to the specified torque. Refer to "COMPONENTS".
8. Remove the pin (3) from adjustment hole after adjusting PNP switch (2).
9. Install the control cable. Refer to Removal and Replacement.
10. Adjust and check A/T position. Refer to Adjustments and Adjustments Testing and Inspection,
11. Check continuity of PNP switch (2). Refer to Component Inspection.
12. Install the air duct (inlet). Refer to Service and Repair Service and Repair.