Operation CHARM: Car repair manuals for everyone.

Removal and Replacement





SHIFT CONTROL SYSTEM


Control Device Removal and Installation


CONTROL DEVICE COMPONENTS






CONTROL CABLE COMPONENTS






REMOVAL

CAUTION:
Make sure that parking brake is applied before removal/installation.
1. Place the selector lever in the "N" position.
2. Remove the center console assembly. Refer to Component Parts.





3. Disconnect the A/T device harness connector (1).
4. Remove the key interlock cable from the control device assembly. Refer to Service and Repair.





5. Remove the bolts (A) from the control device assembly (1).
6. Remove exhaust front tube, center muffler and heat plates. Refer to Component Removal and Installation.





7. Remove the plate (1) from the control device assembly.
Arrow Indicates Vehicle front





8. Remove the lock plate (1) from the control cable (2).
Arrow Indicates Vehicle front
9. Remove the control cable (2) from the control device assembly.
10. Insert suitable tool at points (A) and (B) as shown, and press both tabs (E) and (F) at the front (C) and rear (D) slightly toward the center of the control device assembly to remove the control device assembly from the underside of the vehicle.
Arrow Indicates Vehicle front






INSTALLATION
Installation is in the reverse order of removal.
- When installing the control cable (1) to the control device assembly





(2), make sure that the control cable (1) is fully pressed in with the ribbed surface (A) facing downward from the vehicle.
Arrow Indicates Vehicle front
- After installation is completed, adjust and check the A/T position. Refer to Adjustments and Testing and Inspection.