Removal

SUPPLEMENTAL RESTRAINT SYSTEM: CURTAIN SHIELD AIRBAG ASSEMBLY:

REMOVAL

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

NOTICE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (Repair Instruction - Initialization).

2. REMOVE ROOF HEADLINING ASSEMBLY

HINT:
- Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Double Cab) (Removal).
- Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY" (for Regular Cab) (Removal).

3. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Regular Cab)
(a) Disconnect the connector.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the 6 bolts and curtain shield airbag.





4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY (for Double Cab)
(a) Disconnect the connector.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Remove the 8 bolts and curtain shield airbag.