Installation

1GR-FE ENGINE CONTROL SYSTEM: CRANKSHAFT POSITION SENSOR: INSTALLATION

1. INSTALL CRANKSHAFT POSITION SENSOR

(a) Apply a light coat of engine oil to the O-ring of the sensor.

NOTICE:
* When reusing the sensor, inspect the O-ring.
* If the O-ring has scratches or cuts, replace the sensor.

(b) Install the sensor with the bolt.

Torque : 10 Nm (102 kgf-cm, 7 ft-lbf)

(c) Connect the sensor connector.

2. INSTALL NO. 1 ENGINE UNDER COVER Replacement

3. CONNECT COOLER COMPRESSOR ASSEMBLY Installation

4. INSTALL GENERATOR ASSEMBLY

Installation