Selector Shaft

Selector Shaft

Removing

- Completely remove the air filter housing.

Plastic selector relay lever - 1 -:





- Pull the securing mechanism forward as far as the stop in direction of - arrow 1 - and then unlock to the left in direction of - arrow 2 -.

- Press the selector relay lever forward in direction of - arrow 3 - while pulling the selector cable out of the control cable retainer.

- Remove the selector relay lever with catch to Model Year 2007 => [ Installation Position of Transmission
Shift Lever/Selector Relay Lever ] Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview

- Remove the selector relay lever with catch from Model Year 2008 => [ Remove the Selector Relay Lever from the Transmission Shift Lever and
Attach ] Shift Cable and Selector Cable From Model Year 2008 Assembly Overview

Metal selector relay lever

- Pull off lock washer - 2 - and press selector relay lever - 3 - to the side and out of the bearing.





All Vehicles

• If the selector relay lever cannot be removed due to the transmission bracket, remove the selector cable from the selector relay lever. Remove the slide shoe from the transmission shift lever.

- Remove nut - 4 - and remove transmission shift lever - 1 -.

- Move shift shaft to neutral position.





In the following step, ensure that the selector shaft is not locked by the lock elbow - arrow -.

- Remove back-up light switch (F4) - 1 -.

- Remove mounting bolt - 2 -.

- Remove the bolts - 3 -.

- Remove selector shaft with shift cover - 4 - from transmission housing.

Installing

• Tightening specification, refer to => [ Transmission Housing and Shift Mechanism Assembly Overview ] Transmission Housing and Shift Mechanism Assembly Overview, => [ Shift Mechanism Assembly Overview, Transmission Side ] Shift Mechanism Assembly Overview, Transmission Side.

- Press selector shaft - 1 - against lock sleeve in direction of- 2 - - arrow - and guide downward with shift finger - 3 - through shift forks until stop.





• Shift cover - 4 - must stand parallel to bolting surface on transmission housing during this.

• Selector shaft must be able to be moved easily in selector motion (up- and downward).

• If shift cover stands at an angle to bolting surface, selector shaft is not inserted in lower bearing.

- Tighten the bolts - 3 - for the shift cover - 4 -.





- Install lock bolt - 2 -. Lock elbow - arrow - must not be installed when doing so.

- Install back-up light switch (F4) - 1 -.

- Install the transmission shift lever and selector relay lever. Refer to => [ Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview ] Transmission Shift Lever and Selector Relay Lever to Model Year 2007 Assembly Overview or => [ Shift Cable and Selector Cable from Model Year 2008 Assembly Overview ] Shift Cable and Selector Cable From Model Year 2008 Assembly Overview.

• The transmission shift lever can only be inserted in one position.

- Install the air filter housing.